Media Sensor Adjustment - Datamax Iclass Operator's Manual

3.3 Media Sensor Adjustment

The Media Sensor detects media presence, and top-of-form (except when using continuous
stock). Adjust the Media Sensor as follows:
A. With media loaded and the Printhead Assembly raised for visual access, grasp the Slide
Tab of the Media Sensor.
B. According to your Media Type, use the Slide Tab to position the Sensor Eye Mark as
described in the table below. (Afterward, if necessary, return to the previous section to
complete the setup.)
Media Type
Die-cut
Notched
Reflective
Continuous
Printhead
Assembly
Media
Sensor
Notes: (1) For SENSOR TYPE selection, see Section 4.2.2 (and if using CONTINUOUS
also set LABEL LENGTH).
(2) For SOP adjustments, see Section 4.2.3.
I-Class
Sensor Eye Mark Position
Near the middle of the label
Centered over the notch
Centered over the black mark
Near the middle of the media
Sensor Eye
Mark
Slide
Tab
15