Cylinder Head Bolts; Engine Valve Clearance; Adjusting Accelerator Pedal; Changing Transaxle / Hydraulic Fluid - Toro Workman
3300–D Operator's Manual

• Using a bar, rotate alternator until proper belt
tension is attained, then tighten mounting bolts.
Fan belt
1. Check tension by depressing belt at mid span of fan and
drive shaft pulleys with 22 lbs. of force. A new belt
should deflect .48–.58 in. A used belt should deflect
.55–.65 in. If deflection is incorrect, proceed to next
step. If correct, continue operation.
2. To adjust belt tension:
• Loosen idler pulley mounting nut, move pulley to
increase tension and tighten nut.
Figure 51
1. Fan belt

Cylinder Head Bolts

Re–torque initially after 50 operating hours and check
every 1000 operating hours or annually thereafter.

Engine Valve Clearance

Adjust initially at 50 operating hours and check every 600
operating hours or annually thereafter.

Adjusting Accelerator Pedal

1. Position vehicle on level surface, stop engine and
engage the parking brake.
1
2
2. Idler pulley
45
2. Adjust ball joint on accelerator cable (Fig. 52) to allow
.100"–.250" of clearance between accelerator pedal arm
and top of diamond tread floor plate (Fig. 53), when a
25 lb. force is applied to center of pedal. Tighten
locknut.
Note: Engine must not be running and return spring must
be attached.
2
3
Figure 52
1. Accelerator cable
2. Ball joint
.100–.250" clearance
Figure 53
3. Maximum high idle speed 3650 rpm. High idle stop
should not be adjusted.
Changing Transaxle / Hydraulic
Fluid
Change Transaxle hydraulic fluid, filter and clean strainer
every 800 hours.
1. Position the vehicle on a level surface, stop engine,
engage the parking brake and remove key from ignition
switch.
2. Remove drain plug from side of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and
tighten plug when hydraulic fluid stops draining.
1
3. Locknut