Check Brake Fluid; Check Fan Belt Tension - Toro Workman
3300–D Operator's Manual

Check Brake Fluid

The brake fluid reservoir is shipped from the factory filled
with "DOT 3" brake fluid. Check level before engine is
first started and every 8 hours or daily, thereafter.
1. Park machine on a level surface.
2. Loosen knob securing cup holder to dash (Fig. 19).
Remove cup holder from dash.
Figure 19
1. Cup holder
3. Fluid level should be up to FULL line on reservoir.
Figure 20
1. Brake fluid reservoir
4. If fluid level is low, clean area around cap, remove
reservoir cap and fill to proper level. DO NOT
OVERFILL.
5. Reinstall cup holder to dash.
1
2
2. Knob
1
23

Check Fan Belt Tension

Check all belts for wear, cracking or improper tension.
Check tension by depressing belt at mid span of fan and
drive shaft pulleys with 22 lbs. of force. A new belt should
deflect .48–.58 in. A used belt should deflect .55–.65 in. If
deflection is incorrect, proceed to page 45 for tensioning
procedure. If correct, continue operation.
Important
Improper belt tension may result in
increased steering effort.