Ignition Switch; Light Switch; Oil Pressure Warning Light; Fuel Gauge - Toro Workman
3300–D Operator's Manual

Ignition Switch

The ignition switch (Fig. 23), used to start and stop the
engine, has three positions: OFF, RUN and START. Rotate
key clockwise — START position — to engage starter
motor. Release key when engine starts. The key will move
automatically to the ON position. To shut engine off, rotate
key counterclockwise to OFF position.
Figure 23
1. Charge indicator
2. Coolant temperature
gauge & light
3rd High Lockout Switch
Moving switch (Fig. 23) to slow–
removing key will prevent use of third gear when in the
High range. Engine will shut off if shift lever is moved to
third gear when in High range. Key is installed with teeth
pointing downward. Push key in to turn. Key is removable
in either position.
Glow Plug Switch and Indicator
Use to preheat engine cylinders prior to cold engine starting
procedures. For cold starting, push rocker switch and hold
while watching indicator (Fig. 24). Indicator will glow red
when the glow plugs are activated. Length of time
necessary to preheat cylinders should be determined by
ambient temperature; refer to Starting /Stopping Engine.
1 2
1 1
1 3
4
5
3. Hour meter
4. Ignition switch
5. 3rd high lockout switch
– position and
26

Light Switch

Toggle switch (Fig. 24) to activate headlights. Push to turn
lights "ON".

Oil Pressure Warning Light

Light glows (Fig. 24) if engine oil pressure drops below a
safe level while engine is running. If light flickers or
remains ON, stop vehicle, turn off engine and check oil
level. If oil level was low, but adding oil does not cause
light to go out when engine is restarted, turn engine off
immediately and contact your local TORO distributor for
assistance.
To check operation of warning lights:
1. Apply parking brake.
2. Turn ignition key to "ON", but do not start engine. The
oil pressure light should glow red. If light does not
function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.
Note: If engine was just turned off, it may take 1 to 2
minutes for light to come on.

Fuel Gauge

Shows amount of fuel in tank. Operates only when ignition
switch is in "ON" position (Fig. 24).
5 4
4
3
2
1
Figure 24
1. Glow plug switch
2. Light switch
3. Oil pressure warning light
4. Fuel gauge

Horn Button

Pressing button activates horn (Fig. 24).
6
7
5. Glow plug indicator light
6. Tachometer (Optional)
7. Horn