Fuses; Jump Starting Vehicle - Toro Workman
3300–D Operator's Manual

Fuses

The fuses for the machine's electrical system are located
under the center of the dash panel.
1
Figure 72
1. Fuses
Figure 73

Jump Starting Vehicle

Warning
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in
vehicle, observe the following warnings:
• Never jump start with a voltage sources greater
than 15 volts D.C. This will damage the
electrical system.
• Never attempt to jump start a discharged
battery that is frozen. It could rupture or
explode during jump starting.
• Observe all battery warnings while jump
starting your vehicle.
• Be sure your vehicle is not touching the jump
start vehicle.
• Connecting cables to the wrong post could result
in personal injury and/or damage to the
electrical system.
1. Loosen knobs securing battery cover to battery base and
slide cover off.
2. Connect a jumper cable between the positive posts of
the two batteries. The positive post may be identified by
a "+" sign on top of battery cover.
3. Connect one end of the other jumper cable to the
negative terminal of the battery in the other vehicle. The
negative terminal has "NEG" on the battery cover. Do
not connect the other end of the the jumper cable to the
negative post of the discharged battery. Connect it to the
engine. Do not connect the jumper cable to the fuel
system.
4. Start the engine in the vehicle providing the jump start.
Let it run a few minutes, then start your engine.
5. Remove the negative jumper cable first from your
engine, then the battery in the other vehicle.
6. Reinstall battery cover to battery base and tighten
knobs.
52