Re-Install Full Bed - Toro Workman
3300–D Operator's Manual

5. Lift bed off vehicle.
Caution
The full bed weighs approximately 325 pounds, so
do not try to install or remove it by yourself. Use
an overhead hoist or get the help of two or three
other people.
6. Store cylinders in storage clips. Engage hydraulic lift
lock lever on vehicle to prevent accidental extension of
lift cylinders.
Re–Install Full Bed
Note: If bed sides will be installed on flat bed, it is easier to
install them before bed is installed on vehicle.
Note: Assure rear pivot plates are bolted to the bed
frame/channel so that lower end angles to the rear (Fig. 10).
2
5
Figure 10
1. Left rear corner of bed
2. Vehicle frame channel
3. Pivot plate
Note: Make sure spacer brackets and wear blocks (Fig. 11)
are installed or radiator cover may be damaged. Carriage
bolts heads to be positioned inside the machine.
Caution
The full bed weighs approximately 325 pounds, so
do not try to install or remove it by yourself. Use
an overhead hoist or get the help of two or three
other people.
3
1
4
4. Clevis pin
5. Lynch pin
19
2
3
Figure 11
1. Spacer bracket
2. Wear block
1. Assure lift cylinders are fully retracted.
2. Carefully set bed onto vehicle frame aligning rear bed
pivot plate holes with holes in rear frame channel and
install (2) clevis pins and lynch pins (Fig. 10).
3. With bed lowered, secure each cylinder rod end, to
appropriate slots in bed mounting plates with clevis pin
and lynch pin. Insert clevis pin from outside of bed with
lynch pin toward outside (Fig. 10). Rear slots are for
full bed installation and front slots are for 2/3 bed
installation.
Note: Engine may need to be started to extend or retract
cylinders for alignment with holes. Keep fingers out!
Note: Unused slot can be plugged with a capscrew and nut
to prevent assembly errors.
4. Start engine and engage hydraulic lift lever to raise bed.
Release lift lever and turn off engine. Secure raised bed
with a hoist or block it to prevent it from accidentally
falling.
5. Install lynch pins to inside ends of clevis pins.
Note: If automatic tail gate release has been installed on
bed, make sure front dump link rod has been placed on
inside of left side clevis pin before lynch pin is installed.
6. Once cylinder installation has been completed, the bed
safety support can be used to prevent accidental
lowering of the bed. Refer to Using Bed Safety Support.
1
3. Carriage bolt