Adjusting Clutch Pedal - Toro Workman
3300–D Operator's Manual

Adjusting Clutch Pedal

Check adjustment every 200 hours.
Note: The clutch pedal cable can be adjusted at the bell
housing or at the clutch pedal pivot. Front hood can be
removed to ease access to pedal pivot.
Bell Housing Method
1. Loosen jam nuts securing clutch cable to bracket on bell
housing (Fig. 60).
4
3
Figure 60
1. Clutch cable
2. Jam nuts
Note: Ball joint may be removed and rotated, if additional
adjustment is required.
2. Disconnect return spring from clutch lever.
3. Adjust jam nuts/or ball joint until bottom rear edge of
clutch pedal is 3.75" + .12" from top of floor plate
diamond pattern, when an 4 lb. force is applied to pedal.
Note: Force is applied so release bearing lightly contacts
pressure plate fingers.
4. Reconnect return spring to clutch lever.
5. Verify that rear edge of clutch pedal is 5.5" + .12" from
top of floor plate diamond pattern. If dimension is not
attained, adjust clutch pedal upstop.
Note: The clutch free play should never be less than .75".
6. Tighten jam nuts after adjustment has been attained.
7. Recheck clutch safety switch adjustment (Fig. 61).
Engine must not crank unless clutch pedal is
1.25" ±.12" from floor. If an adjustment is required,
loosen switch jam nuts and adjust up or down.
1
2
3. return spring
4. Ball joint
48
Figure 61
1. Clutch switch
Clutch Pedal Pivot Method
1. Remove nut securing clutch cable ball joint end to
clutch pedal pivot (Fig. 62).
2
3
4
Figure 62
1. Clutch pedal pivot
2. Ball joint end
2. Loosen jam nuts securing clutch cable to frame bracket.
3. Lift up on clutch pedal (Fig. 59) until it contacts frame.
4. Adjust clutch cable until ball joint end is aligned with
hole in clutch pedal pivot. Insert rod end into pivot hole.
5. While holding clutch pedal against frame, tighten jam
nuts securing cable to frame bracket.
6. Secure rod end to pedal pivot with nut previously
removed.
1
1
3. Clutch cable
4. Frame bracket