Configuring Snmp Version 1 And 2C; Configuring Snmp Version 3; Snmp Settings; Configuring Snmp Allowed Addresses - Multitech FaxFinder FF240-IP Administrator's Manual

ADVANCED CONFIGURATION

Configuring SNMP Version 1 and 2C

To configure for SNMP Version 1 and 2C:
1. Go to System Configuration > SNMP.
2. Check Enable SNMP V1/V2C.
3. Enter Community Name. The default value is public.
4. Click Save.

Configuring SNMP Version 3

To configure for SNMP Version 3:
1. Go to System Configuration > SNMP.
2. Check Enable SNMP 3.
3. Enter Username, Password, and Confirm Password.
4. Click Save.
Note: For SNMP Version 3, the security level is Authentication - No Privacy and the Authentication Protocol is
MD5. These settings are not configurable.

SNMP Settings

Field
Community Name
Username
Password
Confirm Password

Configuring SNMP Allowed Addresses

For SNMP versions 1 and 2C, configure allowed IP addresses to specify which networks are allowed to
communicate with FaxFinder. By default, all IP addresses are allowed. As soon as you add one IP address, access
through SNMP V1/V2C will be limited by the IP address list.
Note: Does not apply to SNMP version 3
1. Go to System Configuration > SNMP .
2. Click to open Allowed IP Addresses, then click Add.
3. Enter Network IP address and netmask in the format of ###.###.###.#/XX, where the ###.###.###.###
represents the IP address and the XX represents the netmask. For example, 192.168.0.0/16.
4. Click Save.
5. Repeat Steps 1-3 for each IP address or range you want to add.
Deleting IP Addresses
To delete IP addresses
62
Description
Enter read-only community name. May contain a-z, A-Z, 0-9, - and _. Max length is 32
characters. Required for SNMP V1/V2C. Default is public.
Enter the username required for SNMP V3. Must be between 5-32 characters long. <ay
contain a-z, A-Z, 0-9, - and _.
Enter authentication password required for SNMP V3. Must be between 8-32 characters
long.
Re-enter the authentication password.
®
FaxFinder Fax Server FF240-IP Administrator Guide