Configuring Snmp; Viewing Available Mibs; Configuring Snmp Version 1 And 2C; Configuring Snmp Version 3 - Multitech FaxFinder FF240 Administrator's Manual

ADVANCED CONFIGURATION
1. If you are not on the Store & Forward Fax page, click Fax Configuration > Store & Forward Fax (T.37).
2. Click Add.
3. Enter the hostname or IP address and click Save.

Configuring SNMP

Enable Simple Network Management Protocol (SNMP) on FaxFinder so that your SNMP manager will be able to get
MIB (Management Information Base) values. FaxFinder Server supports SNMP version 1, 2C and 3 read-only
requests.

Viewing Available MIBs

To view available MIBs:
1. Go to System Configuration > SNMP.
2. Click Download MIB.

Configuring SNMP Version 1 and 2C

To configure for SNMP Version 1 and 2C:
1. Go to System Configuration > SNMP.
2. Check Enable SNMP V1/V2C.
3. Enter Community Name. The default value is public.
4. Click Save.

Configuring SNMP Version 3

To configure for SNMP Version 3:
1. Go to System Configuration > SNMP.
2. Check Enable SNMP 3.
3. Enter Username, Password, and Confirm Password.
4. Click Save.
Note: For SNMP Version 3, the security level is Authentication - No Privacy and the Authentication Protocol is
MD5. These settings are not configurable.

SNMP Settings

Field
Community Name
Username
Password
Confirm Password
70
Description
Enter read-only community name. May contain a-z, A-Z, 0-9, - and _. Max length is 32
characters. Required for SNMP V1/V2C. Default is public.
Enter the username required for SNMP V3. Must be between 5-32 characters long. <ay
contain a-z, A-Z, 0-9, - and _.
Enter authentication password required for SNMP V3. Must be between 8-32 characters
long.
Re-enter the authentication password.
®
FaxFinder Fax Server FF240, FF440, FF840 Administrator Guide