Table of Contents
Advertisement
4 0
ADDENDUM #1 Class A Chimney Conversion Kit
Simpson Duravent provides a conversion kit for
those wishing to use an existing wood stove
chimney to vent this direct vent stove. The
illustration below gives an overview of this type of
installation. See the instructions included with the
kit for details.
!
Do not exceed the maximum vertical rise (see the
section "Approved Vent Configurations" starting on
page 12) allowable. Remember to set the restrictor
position to the correct position (based upon the
vertical rise height - see the chart on page 15).
!
The conversion kit does not work on interior masonry
chimneys.
Chimney Conversion Kit A (# 931)
Metalbestos 6" I.D.
Security Chimneys 6" I.D.
Jackes-Evans 6" I.D.
Hart & Cooley 6" I.D.
Pro-Jet 6" I.D.
Chimney Conversion Kit B (# 932)
Simpson Dura-Vent 6" I.D.
Air-Jet 6" I.D.
Metal-Fab 6" and 7" I.D.
Amer. Metals 6" & 7" I.D.
Metalbestos 7" and 8" I.D.
Jackes-Evans 7" and 8" I.D.
Hart & Cooley 7" and 8" I.D.
Pro-Jet 7" and 8" I.D.
Security Chimneys 8" I.D.
Chimney Conversion Kit C (# 933)
Simpson Dura-Vent 7" and 8" I.D.
American Metals 8" I.D.
Air-Jet 8" I.D.
Metal-Fab 8" I.D.
American Metals 8" I.D.
Each Kit Contains:
Retro Connector
Retro Vertical Top
Additional Required Equipment:
4" Flex (#711 or U.L. 1777)
Termination (#991)
Co-Axial Sections
Travis Industries
Installation Addenda
1 0 0 - 0 1 1 4 2
Screw the Retro
Vertical Top to the
Flex Pipe
Type A Chimney
4" (100 mm)
Aluminum Flex
Pipe
Retro Connector
(screw to chimney)
Simpson Duravent Direct
Vent Pipe Sections
(use adjustable section)
Retro Vertical Top
(screw to chimney)
Cut the Flex Pipe to
the chimney height
plus 3" (75 mm)
Screw the Retro
Connector to the
Flex Pipe
4 0 5 0 1 1 4
Hide quick links:
Advertisement
Table of Contents
