Fireback - Lopi Direct Vent Freestanding Stove Owner's Manual

Optional Equipment
3 8

Fireback

(Part # 99900146)
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
Make sure the heater is
shut off (pilot out) and
fully cool prior to
installation.
The firebacks are
fragile – especially
after being heated.
1 Remove the burner
(see page 33).
2 Follow the instructions
to the right to install
the firebacks.
3 Replace the burner
support to its original
position and replace
the burner.
Travis Industries
a
Remove this screw and bend the left side
of the burner support back slightly. This
allows for installation of the left side
fireback. After the fireback is installed,
return the burner support and screw to
their original position.
b
Place the rear fireback on the clip
attached to the back wall of the
firebox.
c
Place the top fireback on top of the rear
fireback. Slide the side firebacks into
place (the side firebacks hold the top
fireback in place). There are two screws
protruding from the top of the firebox -
you may need to pivot the side firebacks
into place.
1 0 0 - 0 1 1 4 2
(for qualified installers only)
5/16" Nutdriver
4 0 5 0 1 1 4