Blower - Lopi Direct Vent Freestanding Stove Owner's Manual

Optional Equipment
3 6
Blower (part # 99000154)
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
WARNING: This appliance is equipped with a three-prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded three-
prong receptacle. Do not cut or remove the grounding prong from this plug.
1 Slide the thermodisk into the holder underneath the firebox.
2 Attach the blower following the directions below.
Travis Industries
11/32" Nutdriver
1 0 0 - 0 1 1 4 2
(for qualified installers only)
Attach the grommets (with spacers) to
a
the right side fan mounting bracket with
the included nuts and washers.
Slide the fan mounting plate into
b
the slot on each of the rubber
grommets.
Fan Mounting Bracket
(attached to stove)
Washer
Nut
Blower Mounting Bracket
Slide the rubber grommets (with spacers inserted
c inside) onto the fan mounting plate and attach
using the included washers and nuts.
Snap Disk Bracket
(attached to stove)
Snap Disk
Rubber Grommet
(with spacer)
4 0 5 0 1 1 4