Other Problems; The Machine Does Not Move - Roland Texart RT-640 User Manual

Other Problems

The Machine Does Not Move

Is the cable connected?
Connect the cable securely.
 "Setup Guide"
Is the power switched on?
Switch on the machine's main power, then press the sub power switch and make sure the sub power switch
lights up.
P. 17"Switch On!"

Is a cover open?
Close the front, left, and right covers.
Is illuminated?
Printing is not performed when
P. 47"Getting Ready to Receive Data from a Computer"

Is the top menu displayed?
Top menu
If the top menu is not displayed, printing does not start even when data is sent from the computer. To go to
the top menu, press
P. 47"Getting Ready to Receive Data from a Computer"

Is a message displayed on the screen?
P. 122"A Message Appears"

Is illuminated?
6
When
resumes.
P. 49"Pausing or Canceling Printing"

Has ink run out?
When the screen shown above is displayed, print data cannot be accepted.
If the screen shown above is displayed during printing, the behavior of the machine depends on the [EMPTY
MODE] setting. (Only when 8 colors are selected)
 When "STOP" is selected: Printing operation is paused.
 When "CONT." is selected: A warning beep sounds, and printing continues until the machine has finished
printing the print data it has accepted. In this case, it is also possible to press
120
is not illuminated. Lower the loading lever.
, then press
, P. 123"An Error Message Appears"
lights up, operation is paused. To resume, press
.
. goes dark and printing
and pause printing.