Printing; Setting The Printing-Start Location - Roland Texart RT-640 User Manual

Printing

Setting the Printing-start Location

The printing-start location can be set to any location you desire. (It is possible to print even if this settings is
not configured.) Note, however, that this setting must be made for each individual page. When the printing
of one page finishes, the printing-start location returns to its default value.
Procedure
2

Press
When a cursor key is pressed, the warm-up operation to move the media or the print-head carriage starts.
When the warm-up operation finishes, move the media and the print-head carriage to the position where
you want to printing to start.
The printing-start location is determined by the position
settings of the feed and scan directions.

When the location is set, press

 Note that the left and right positions are not restored to their defaults for test patterns.
 When using the separately available media take-up system (TUC-3), if
the machine stops for a fixed interval to protect the motor. If the machine stops, wait for around
5 seconds, and then resume operation.
44
Printing area
Printing-start
location
Printing-start location in scan (left–right) direction
Base point
mark
When the screen on the left is displayed, press
to confirm.
acter "B" together with the printable width at the location, setting is
completed.
to move the media and the print-head carriage.
Printing-start location in feed
(forward–backward) direction
Move the media to adjust the
feed direction.
The base point mark on the
right side of the print head
carriage is the start location
in the scan direction.
.
remains steadily lit and when the screen displays the char-
Cutter guide
is held down,