An Error Message Appears - Roland Texart RT-640 User Manual

An Error Message Appears

This describes the error messages that may appear on the machine's display, and how to take
action to remedy the problem. If the action described here does not correct the problem, or if
an error message not described here appears, contact your authorized Roland DG Corp. dealer.
[CAN'T PRINT CROP CONTINUE?]
The size of the data including the crop marks is larger than the printing or cutting area of
the loaded media.
To continue printing without correcting this, press
printing area and the crop marks are not printed. To stop printing, stop sending data from the computer, then
raise the loading lever. Make the printing area wider, for example by replacing the media with a larger piece
of media, then send the data again.
The size of the data being printed is too small.
Make the scanning-direction size of the data at least 65 mm (2.6 in). To continue printing without correcting this,
press . At this time, the data is output without printing the crop marks. To stop printing, stop sending
data from the computer, then raise the loading lever. Change the size of the data, then send the data again.
[TEMPERATURE IS TOO HIGH **°C]
The temperature of the location where the machine is installed has risen above the ambient
temperature at which the machine can operate.
Operation cannot be continued. Switch off the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation is
possible (18 to 25°C (64 to 77°F)) and allow the machine to come to room temperature, then turn on the power.
[TEMPERATURE IS TOO LOW **°C]
The temperature of the location where the machine is installed has fallen below the ambient
temperature at which the machine can operate.
Operation cannot be continued. Switch off the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation is
possible (18 to 25°C (64 to 77°F)) and allow the machine to come to room temperature, then turn on the power.
[SERVICE CALL xxxx]
An unrecoverable error occurred, or part replacement that must be performed by a service
technician is required.
Note the number displayed on the display screen, then switch off the sub power. After you switch off the power,
inform your authorized Roland DG Corp. dealer or Roland Corp. of the number that appeared on the display.
[SHEET TOO SMALL CONTINUE?]
The size of the data is larger than the printing area of the loaded media
To continue printing without correcting this, press
printing area is not printed. To stop printing, stop sending data from the computer, then raise the loading
lever. Make the printing area wider, for example by replacing the media with a larger piece of media, then
send the data again.
. At this time, the portion extending beyond the
. At this time, the portion extending beyond the
6
123