Site Requirements; Location Of The Serial Number; Water Supply Install; Autopod - Bunn AutoPOD Technical Training Manual
Hide thumbs
Also See for AutoPOD:
- Installation & operating manual (15 pages) ,
- Illustrated parts catalog (15 pages) ,
- Programming manual (9 pages)
Table of Contents
Advertisement
Installation
Site Requirements
Space
• AutoPOD™ is only for indoor use on a sturdy counter or shelf
• AutoPOD™ dimensions is 15.8"H x 9.7" W x 15.2" D (40.1cm H x 24.6cm W x 38.6cm D)
• Weight 30 lbs
Water Treatment
• Sediment filtration to reduce large particles
• Taste and odor filter to remove chlorine
• Scale filtration as needed
• For best results a BUNN
Plumbing
• Elbow adapter fitting provided to convert to ¼" male flare fitting
• Dedicate water supply with shut-off
• Connected to the cold water supply
• Water pressure 20-90psi, set to 50psi if regulator is needed
• If a backflow preventer is required by code, a shock arrestor should be installed close to the ma
chine between the backflow preventer and the machine
Electrical
• 120VAC, 2 wire plus ground
• Dedicated 15Amp circuit breaker
• Receptacle within 5 feet of machine
Location of the Serial Number
The machine's serial number is located on the data plate which is located on the lower front panel behind the waste
bin and drip tray. The serial number half tag can be found on the inside of the machine attached to the left side wall.
Removing top lid will give you access to the serial number only tag.
Water Supply Install
Step 1: Check water pressure, install pressure regulator before water filter if above 90 psi and set to 50 psi.
Step 2: Install water filter and purge before installation.
Step 3: Securely attach the adaptor elbow assembly to the ¼" water supply line from the filter. If using AutoPOD™
with pump it will have an elbow adapter
with a pressure regulator assembly. The
machine pressure regulator is factory set
at 10 psi; do not adjust. The purpose is to
accommodate locations with low incoming
or fluctuating water pressure.
Step 4: Securely attach adapter elbow as-
sembly to the .75-11.5 NH (Hose Thread)
fitting at the rear of the brewer and turn on
the water supply.
4
AutoPOD™ Training Manual
Easy Clear
filtration system should be used
®
®
Advertisement
Table of Contents
