User Interface; Programming Lockout Switch - Bunn AutoPOD Technical Training Manual

Setup and Programming

User Interface

The switch decal adheres to the front housing over the electronic switch and LCD (Liquid Crystal Display) board. The
mechanical switches are mounted directly onto the electronic board with a button mounted on the stem for product
actuation. The switch decal is nothing more than a overlay with description of the buttons. The user interface allows
the user to program the brewer for product recipes and begin the brew process with the selection of large or small
cup. The AutoPOD™ brewer also gives the user the option of a Hot Water dispense.
Switch Operation "Programming"
Open/Close
"No" or (-)
Small Brew (B)
Step backwards
through screens
Switch Operation "Operating Controls"
Open/Close
Used to open and
close the pod
holder door
Small Brew (B)
Preset but can be
adjusted

Programming Lockout Switch

The programming lockout switch is located on the main control
board. This switch can be set to prevent access to the program-
ming settings of the brewer. Once all the correct brew settings are
programmed, the operator can set the switch to the "On" position to
prohibit anyone from changing the settings. With the switch in the
"On" position, the programming menus can still be accessed to view
the current settings. However, no changes will be saved.
To access the lockout switch:
Step 1: Disconnect brewer from power source before removing any
panel.
Step 2: Remove the rear panel by removing six standard screws.
Hidden Switch
Step forward through
screens
Hot Water
"Yes" or (+)
Large Brew (A)
"Done"
Hot Water
Push and hold to
dispense hot water
only (Max 10 oz.)
Large Brew (A)
Preset but can be
adjusted
Bunn-O-Matic Corporation
7