Site Requirements; Location Of The Serial Number; Water Supply Install - Bunn My Cafe AP Technical Training Manual

Installation

Site Requirements

Space
• My Caf é AP is only for indoor use on a sturdy counter or shelf
• My Caf é AP dimensions are 15.79"H x 9.5" W x 18.4" D (40.1cm H x 24.13cm W x 46.73cm D)
• Weight 30 lbs (13.6 kg.)
Water Treatment
• Sediment filtration to reduce large particles
• Taste and odor filter to remove chlorine
• Scale filtration as needed
• For best results a BUNN
Plumbing
• Elbow adapter fitting provided to convert to ¼" male flare fitting
• Dedicate water supply with shut-off
• Connected to the cold water supply
• Water pressure 20-90psi, set to 50psi if regulator is needed
• If a backflow preventer is required by code, a shock arrestor should be installed close to the ma
chine between the backflow preventer and the machine
Electrical
• 120VAC, 2 wire plus ground
• Dedicated 15Amp circuit breaker
• Receptacle within 5 feet of machine

Location of the Serial Number

The machine's serial number is located on the data plate which is located on the lower front panel behind the waste
bin and drip tray. The serial number half tag can be found on the inside of the machine attached to the left side wall.
Removing top lid will give you access to the serial number only tag.

Water Supply Install

Step 1: Check water pressure, if above 90 psi, install pressure regulator and set to 50 psi before water filter.
Step 2: Install water filter and purge before installation.
Step 3: Securely attach the adaptor elbow
assembly to the ¼" water supply line from
the filter.
Step 4: Securely attach adapter elbow as-
sembly to the .75-11.5 NH (Hose Thread)
fitting at the rear of the brewer and turn on
the water supply.
4
My Caf é AP Training Manual
Easy Clear filtration system should be used
® ®