Cellular Configuration Screen - ZyXEL Communications ZyWall 110 User Manual

Table 92 Configuration > Network > Interface > PPP > Add (continued)
LABEL
Check this
address
Check Port
Related Setting
Configure WAN
TRUNK
Policy Route
OK
Cancel

9.5 Cellular Configuration Screen

Mobile broadband is a digital, packet-switched wireless technology. Bandwidth usage is optimized
as multiple users share the same channel and bandwidth is only allocated to users when they send
data. It allows fast transfer of voice and non-voice data and provides broadband Internet access to
mobile devices.
Note: The actual data rate you obtain varies depending on the mobile broadband device
you use, the signal strength to the service provider's base station, and so on.
You can configure how the ZyWALL/USG's mobile broadband device connects to a network (refer to
Section 9.5.1 on page
• You can set the mobile broadband device to connect only to the home network, which is the
network to which you are originally subscribed.
• You can set the mobile broadband device to connect to other networks if the signal strength of
the home network is too low or it is unavailable.
3G
3G (Third Generation) is a digital, packet-switched wireless technology. Bandwidth usage is
optimized as multiple users share the same channel and bandwidth is only allocated to users when
they send data. It allows fast transfer of voice and non-voice data and provides broadband Internet
access to mobile devices.
4G
4G is the fourth generation of the mobile telecommunications technology and a successor of 3G.
Both the WiMAX and Long Term Evolution (LTE) standards are the 4G candidate systems. 4G only
supports all-IP-based packet-switched telephony services and is required to offer gigabit speed
access.
Chapter 9 Interfaces
DESCRIPTION
Select this to specify a domain name or IP address for the connectivity check. Enter
that domain name or IP address in the field next to it.
This field only displays when you set the Check Method to tcp. Specify the port
number to use for a TCP connectivity check.
Click WAN TRUNK to go to a screen where you can configure the interface as part of a
WAN trunk for load balancing.
Click Policy Route to go to the screen where you can manually configure a policy
route to associate traffic with this interface.
Click OK to save your changes back to the ZyWALL/USG.
Click Cancel to exit this screen without saving.
213):
ZyWALL/USG Series User's Guide
210