ZyXEL Communications ZyWall 110 User Manual page 172

Figure 143 Configuration > Wireless > DCS
Each field is described in the following table.
Table 80 Configuration > Wireless > DCS
LABEL DESCRIPTION
General Settings
Select Now Click this to have the managed APs scan for and select an available channel
immediately.
Enable Dynamic Select this to turn on dynamic channel selection for the APs that the ZyWALL/USG
Channel Selection manages.
DCS Time Interval Enter a number of minutes. This regulates how often the ZyWALL/USG surveys the
other APs within its broadcast radius. If the channel on which it is currently
broadcasting suddenly comes into use by another AP, the ZyWALL/USG will then
dynamically select the next available clean channel or a channel with lower
interference.
Enable DCS Client Select this to have the AP wait until all connected clients have disconnected before
Aware switching channels.
If you disable this then the AP switches channels immediately regardless of any client
connections. In this instance, clients that are connected to the AP when it switches
channels are dropped.
2.4 GHz Settings
2.4 GHz Channel Select auto to have the AP search for available channels automatically in the 2.4 GHz
Selection Method band. The available channels vary depending on what you select in the 2.4 GHz
Channel Deployment field.
Select manual and specify the channels the AP uses in the 2.4 GHz band.
Chapter 8 Wireless
ZyWALL/USG Series User's Guide
172