ZyXEL Communications ZyWall 110 User Manual page 34

Table 7 Configuration Menu Screens Summary (continued)
FOLDER OR LINK TAB
Registration Registration
Service
Signature Anti-Virus
Update
IDP/AppPatrol
Wireless
Controller Configuration
AP Mgnt AP List
Management
AP Policy
MON Mode Rogue/Friendly AP
List
Load Balancing Load Balancing
DCS DCS
Auto Healing Auto Healing
Network
Interface Port Role
Ethernet
PPP
Cellular
Tunnel
VLAN
Bridge
Trunk
Routing Policy Route
Static Route
RIP
OSPF
DDNS DDNS
NAT NAT
HTTP Redirect HTTP Redirect
ALG ALG
UPnP UPnP
IP/MAC Summary
Binding
Exempt List
Chapter 1 Introduction
FUNCTION
Register the device and activate trial services.
View the licensed service status and upgrade licensed services.
Update anti-virus signatures immediately or by a schedule.
Update IDP signatures immediately or by a schedule.
Configure manual or automatic controller registration.
Edit or remove entries in the lists of APs managed by the ZyWALL/
USG.
Configure the AP controller's IP address on the managed APs and
determine the action the managed APs take if the current AP
controller fails.
Configure how the ZyWALL/USG monitors rogue APs.
Configure load balancing for traffic moving to and from wireless
clients.
Configure dynamic wireless channel selection.
Enable auto healing to extend the wireless service coverage area of
the managed APs when one of the APs fails.
Use this screen to set the ZyWALL/USG's flexible ports such as
LAN, OPT, WLAN, or DMZ.
Manage Ethernet interfaces and virtual Ethernet interfaces.
Create and manage PPPoE and PPTP interfaces.
Configure a cellular Internet connection for an installed mobile
broadband card.
Configure tunneling between IPv4 and IPv6 networks.
Create and manage VLAN interfaces and virtual VLAN interfaces.
Create and manage bridges and virtual bridge interfaces.
Create and manage trunks (groups of interfaces) for load
balancing.
Create and manage routing policies.
Create and manage IP static routing information.
Configure device-level RIP settings.
Configure device-level OSPF settings, including areas and virtual
links.
Define and manage the ZyWALL/USG's DDNS domain names.
Set up and manage port forwarding rules.
Set up and manage HTTP redirection rules.
Configure SIP, H.323, and FTP pass-through settings.
Configure interfaces that allow UPnP and NAT-PMP connections.
Configure IP to MAC address bindings for devices connected to
each supported interface.
Configure ranges of IP addresses to which the ZyWALL/USG does
not apply IP/MAC binding.
ZyWALL/USG Series User's Guide
34