Cleaning The Photoconductor Belt Module - NEC Super Script 4400 Maintenance Manual

C
LEANING THE PHOTOCONDUCTOR BELT MODULE
The photoconductor belt module is sensitive to bright light and touch. Always wrap it in a soft dark cloth until you
are ready to clean or install it. A dry cotton cleaning cloth is needed for this procedure
1. Turn off and unplug the printer.
2. Open the Front and Top covers of the printer (A).
3. Release the Lock Levers (B) and carefully remove the photoconductor belt module (C).
4. Using a dry cloth, clean any toner buildup from around the cleaning blade.
5. Clean any toner or paper dust photoconductor belt module itself.
6. Remove the small cleaning brush from inside the front of the printer (D).
7. Turn the photoconductor belt module so that the handle is facing away from you.
8. Use the brush to gently clean the wire inside the end of the photoconductor belt module. Do not press hard on
the wire (E).
9. Reinstall the photoconductor belt module (F)and secure the Lock Levers (G).
10. Return the cleaning brush to its holder and close the printer's covers (H)
108 SuperScript 4400 — Maintenance Guide