Replacing The Photoconductor Belt Module - NEC Super Script 4400 Maintenance Manual

R
EPLACING THE PHOTOCONDUCTOR BELT MODULE
Part number 20--205
1. Turn off the printer (A).
2. Open the Front and Top Cover (B).
3. Flip up the Lock Levers to release the photoconductor belt module (C).
4. Pull the old photoconductor belt module straight up and discard it (D).
5. Remove the black wrapper from the new photoconductor belt module and pull out the two tension release
pins as shown (E).
WARNING! Do not touch the green material on the photoconductor belt module. It is easily scratched.
6. With the flat side of the photoconductor belt module facing the front, insert it straight into the guide slots in
the lock levers. The white gear on the cartridge goes to the right. Do not use force (F).
7. Flip down the Lock Levers (G).
8. Close the Front and Top Covers.
9. Reset the Operator Panel to make sure the consumable usage information is current.
A
B
E
110 SuperScript 4400 — Maintenance Guide
C
F
D
G