NEC Super Script 4400 Maintenance Manual page 259

LCD Message
Booting...
OUT OF PAPER
TRAY 2 UNSUPPORTED SIZE
PAPER MISMATCH LOAD
<Paper Size> TRAY
<K, Y, M, or C> TONER EMPTY
<K, Y, M, or C> TONER NOT FOUND
PAPER JAM DRUM
PAPER JAM INNER/DRUM
PAPER JAM EXIT/DRUM
MISFEED
CHECK WASTE TONER
REPLACE FUSER OIL
REPLACE FUSER ROLLER
MISPRINT HW FAULT
photoconductor belt module NOT
FOUND
FUSER UNIT NOT FOUND
FUSER ROLLER NOT FOUND
FRONT COVER OPEN
BACK COVER OPEN
TOP COVER OPEN
LOW FUSER OIL
NEAR END FUSER ROLLER
REPLACE BELT
REPLACE FUSER UNIT
K-TONER LOW
<Y, M, or C> TONER LOW
120K SERVICE
CASSETTE OUT <TRAY 1 or 2>
MEDIA MISMATCH LOAD <MEDIA>
TRAY
250 SuperScript 4400 — Maintenance Guide
Explanation
First message to appear when the printer is powered up.
One of the paper trays is empty
Lower tray contains paper size that is not supported by engine.
Paper tray does not have the correct paper size as specified for
the print job. Load the paper size shown on the display <Letter,
Legal, A4, B5JIS, B5ISO, EXEC, FOLIO, FSCAP , SPFOLI,
QUARTO, COM-10, or DL>.
Specified toner module is empty. Replace it with a new one.
Specified toner module is not installed or installed incorrectly.
Reinstall it.
Paper jam in drum area.
Paper jam in inner area.
Paper jam in exit tray.
Paper misfeed.
Waste toner pack is full or is not installed.
Fuser oil has run out.
Fuser cleaning roller needs to be replaced.
Printing error caused by no PRREQ-N within a page. ???
Photoconductor Belt Module photoconductor belt module is not
installed.
Fuser unit is not installed.
Fuser cleaning roller is not installed.
Front Cover is open.
Back Cover (transfer unit) is open.
Top Cover is open.
Fuser cleaning unit has about 30 pages of operation remaining.
Fuser cleaning roller has about 1000 pages of operation
remaining.
Photoconductor Belt Module photoconductor belt module worn
out.
Fuser unit reaches end-of-life.
Black Toner Module has less than 300 pages of operation
remaining.
Specified Toner Module has less than 500 pages of operation
remaining.
Paper discharge, drum cleaner, transfer roller, transfer drum,
and paper pick-up roller all need to be replaced.
Cassette is not installed in Paper Tray 1 or 2.
Tray does not have the correct media as specified for the print
job. Load the media shown on the display <Paper, Label, or
OHT (Over Head Transparency)>.