Table of Contents
Advertisement
7 .5.7 Oil Sensor (OIL)
Tools
Phillips Screwdriver #1, #2
Disassembly Procedures
1.
Remove the fuser unit.
2.
Remove the side cover (LU). (See the item 7.1.1.)
3.
Remove the side cover (L). (See the item 7.1.2.)
4.
Remove the top cover. (See the item 7.1.4.)
5.
Remove the controller case 'A' assembly. (See the item 7.2.5.)
6.
Disconnect the oil sensor connector.
7.
Remove the sensor cover.
8.
Remove the set screw ST3 6 (2 pcs.) of oil sensor.
9.
Remove the oil sensor.
Assembly Procedures
1.
Install a new oil sensor.
2.
After the above , follow exactly the reverse order of disassembling procedures.
Cover F
Oil Sensor
Replacement Procedures for Maintenance Parts
175
Advertisement
Chapters
Table of Contents
