NEC Super Script 4400 Maintenance Manual page 79

Unit Status: Click here to view the current state for each protocol and NIC port available on your NIC. For
each supported protocol (Novell NetWare, TCP/IP, or AppleTalk), the top line displays the protocols
supported and if the protocol is enabled or disabled.
Network Address: Click here to view the serial number and the Ethernet MAC (Media Access Control)
address for the NIC.
Change Password: Changing any NIC parameters using the NIC Configuration Menu requires a password.
Click here to change your password. The default password is sysadm. Your password can contain letters,
numbers, and punctuation, and is case sensitive.
note:
If you forget your password, you can restore factory defaults manually. See page xx.
Protocol Functions
The Protocols feature is for setting up network options and parameters. It provides extensive access to NIC
parameters, and allows you to setup IP parameters (IP address, subnet mask, and default gateway). You can
enable/disable AppleTalk and NetWare, but not TCP/IP. (We recommend that you disable any protocol that you
are not using.)
Other Functions
Test Printer: Click here, and then click on the Start Test button in the dialog box that appears, to send a test
document to the printer.
Configure Status Page: Click here to configure Network Settings page options. In the dialog box that
appears, select the checkbox by Print Status Page on Startup to generate a status page (the Network Settings
page) each time you turn on the printer or reset the NIC.
note:
We recommend that you leave this setting checked to print at power-on.
To print out a Network Settings page immediately, click Generate Now.
Printer Status: Click here to display status information for the printer and NIC, as well as errors and
messages.
70 SuperScript 4400 — Maintenance Guide