NEC Super Script 4400 Maintenance Manual page 67

WARNING! It takes two adults to lift the printer and assure that it is level. If the printer is tipped more than 1.5
degrees, oil will spill inside and cause damage.
5. Locate the metal tab with screw hole on each side of the Paper Tray 2 unit.
6. Take a metal bracket from the packet and hold it at a slight angle away from you. Slide the bracket up into the
hole underneath the printer (B).
7. Making sure the hole in each metal bracket is lined up with the corresponding screw hole on the Paper Tray 2
unit, insert and tighten the thumb screws (C).
8. Facing the back of the printer, locate the Connector Cable at the rear of the Paper Tray 2 unit.
9. Remove the cable connector door at the rear of the printer (D) and connect the cable to the printer socket (E).
10. Place the cable connector door that you removed from the printer on the Paper Tray 2 unit. Place the cable
connector door that you removed in step 3 over the cable opening on the back of the printer.
11. Snap on the left and right Paper Tray 2 unit covers.
12. Reconnect the power and interface cables to your printer.
13. Load paper into your new Paper Tray 2, turn your printer on and send a print job to the printer using paper
from both trays.
Adding Paper Tray 2 Unit
D
F
58 SuperScript 4400 — Maintenance Guide
E
Switch cable connector doors
after connecting cable!
G