40
Lights and Visibility
Lights and Visibility
Lights
Switching lights on and off
Switching on side lights
–
Turn the light switch into position
Switching on the low beam and main beam
–
Turn the light switch into position
–
Press the main beam lever forward in order to switch on the main beam
page 42, fig.
38.
Switching off lights (except daylight driving lights)
–
Turn the light switch into position°0.
Low beam comes on only if the ignition is switched on. After switching off the igni-
tion, the low beam is switched off automatically and only the side lights come on.
On models fitted with right-hand steering the position of certain switches differs
fig.
from that shown in
34. The symbols which mark the switch positions are
identical, however.
WARNING
Never drive with side lights on - risk of accident! The side lights are not bright
enough to light up the road sufficiently in front of you or to be seen by other
Fig. 34 Dash panel: Light switch
.
.
WARNING (continued)
oncoming traffic. In this case, always switch on the low beam when it is dark or
if visibility is poor.
Note
•
An audible warning will sound if you withdraw the ignition key and open the
driver's door when the vehicle lights are still on.
•
The acoustic warning signal is switched off over the door contact when the
driver's door is closed (ignition off). The vehicle can be parked with the side lights
on.
•
If the car is parked for a lengthy period, we recommend switching off all lights,
or leaving only the parking lights switched on.
•
The switching on of the described lights should only be undertaken in accord-
ance with the legal requirements.
•
If a fault occurs in the light switch, the low beam comes on automatically
•
In the event of cool or humid weather conditions, the headlights can be misted
up from inside.
− The temperature difference between interior and external area of the head-
light lenses is decisive.
− When the driving lights are switched on, the light outlet surfaces are free
from mist after a short period. The headlight lenses can possibly mist up at the
border areas.
− It also concerns reverse light and turn signal lights.
− This mist has no influence on the life of the lighting system.
"DAY LIGHT"*
Switching on daylight driving lights
–
Switch on the ignition without turning the light switch out of the position 0.
Deactivating the function daylight driving lights
–
Pull the turn signal light lever towards the steering wheel up to 3 seconds after
switching on the ignition and at the same time, slide it to the bottom and hold
it in this position for at least 3 seconds.