48
Lights and Visibility
–
With the other hand unlock the locking button
remove the wiper blade.
Attaching a wiper blade
–
Position the wiper blade onto the wiper arm and lock the locking button
–
Check whether the wiper blade is correctly attached.
The same remarks apply here as for page 47, "Replacing wiper blades for the
windscreen wipers".
Rear-view mirror
Manual dimming interior rear-view mirror
Basic setting
–
Pull the lever on the bottom edge of the mirror forward.
Dimming mirror
–
Pull the lever on the bottom edge of the mirror back.
Exterior mirror
You can adjust the exterior mirrors electrically*.
The exterior mirror heater only operates when the engine is running and up to an
outside temperature of +20 °C.
in the direction of arrow and
A
.
A
Fig. 46 Inner part of door: Rotary knob
Heating of the external mirror
–
Turn the rotary knob to position
Adjusting left and right exterior mirrors simultaneously
–
Turn the rotary knob to position
tical to the movement of the rotary knob.
Adjusting the right-hand exterior mirror
–
Turn the rotary knob to position
tical to the movement of the rotary knob.
Switching off operating control
–
Turn the rotary knob to position
WARNING
•
Convex (curved outward) or spherical (differently curved) exterior mirrors
increase the vision field. They do, however, make objects appear smaller in the
mirror. These mirrors are only of limited use, therefore, for estimating distances
to the following vehicles.
•
Use whenever possible the interior rear mirror, for estimating the distances
to the following vehicles.
Note
•
Do not touch the surfaces of the exterior mirrors if the exterior mirror heater is
switched on.
•
You can set the exterior mirrors by hand, if the power setting function fails at
any time by pressing on the edge of the mirror surface.
•
Contact your specialist garage if a fault exists with the power setting of the
exterior mirrors.
fig.
46.
. The movement of the mirror surface is iden-
. The movement of the mirror surface is iden-
.