130
Inspecting and replenishing
Inspecting and replenishing
Engine compartment
Bonnet remote release
Bonnet remote release
–
Pull the unlocking lever below the dash panel on the driver's side
The bonnet jumps out of its lock as a result of the spring force. A locking lever
appears at the same time in the radiator grille.
Opening and closing the bonnet.
Fig. 121 Radiator grille: Release lever / securing the bonnet with the bonnet support
Fig. 120 Bonnet release lever
fig.
120.
Opening the bonnet
fig.
–
Unlock the bonnet
120.
–
Ensure that the arms of the windscreen wipers are correctly in place against the
windscreen before opening the bonnet otherwise damage could occur to the
paintwork.
–
Pulling on the release lever in direction of arrow
bonnet.
–
Grip with the hand under the radiator grille and lift up the bonnet.
–
Take the bonnet support out of its holder and set it in the opening
bonnet.
Closing the bonnet
–
Lift the bonnet slightly and unhook the bonnet support. Press the bonnet
support into the holder designed to hold it.
–
Allow the bonnet to drop from a height of about 20 cm into the lock - bonnet do
not press down on it!
WARNING
•
Never open the bonnet if you see that steam or coolant is flowing out of the
engine compartment - risk of scalding! Wait long enough until the steam or
coolant has stopped escaping.
•
For safety reasons, the bonnet must always be properly closed when driving.
One should therefore check that the lock has in fact engaged properly after
closing the bonnet.
•
Stop your vehicle immediately while driving if you notice that the lock is not
properly engaged and close the bonnet properly - risk of an accident!
Caution
Never open the bonnet using the locking lever - danger of causing damage.
fig. 121
will unlock the
1
on the
2