Skoda Octavia Tour Owner's Manual page 53

52 Seats and Stowage
WARNING (continued)
•
Pay attention that the seat backrests are correctly interlocked. It is only then
that the three-point seat belt for the middle seat can reliably fulfil its function.
•
Before folding the seat backrest back into the secure position, place the rear
lateral seat belt behind the edge of the side trim panel. Take suitable measures
to prevent that the seat belt is jammed between the seat backrest and the side
trim panel and is thus damaged.
Removing the seat cushion
You can enlarge the luggage compartment on vehicles with divided rear seats* by
removing the rear seat.
Removing
– Fold the seat cushion forwards completely.
– Press the wire clamps in the direction of the arrow
seat cushion from its holder.
Installing
– Press the wire clamps in the direction of the arrow and place it in its holder.
– Fold the seat cushion back into its original position.
Fig. 52 Removing seat cushions
 fig. 52
and remove the
Rear seat armrest*
– You can fold down the armrest at the loop to enhance occupant comfort
 fig.
53.
Seat heaters*
You can electrically heat the seat cushions and the seat backrests of the front seats.
– You can switch on and regulate the seat heating of the driver or front passenger
seat by pressing the surface of the regulator at the point at which the symbol is
located   fig. 54.
– With one press, you can switch the heating to highest intensity which is indi-
cated by the lighting up of the three warning lights in the switch.
– With repeated pressing of the switch, the intensity of the heating is down-regu-
lated up to the switch-off. The intensity of the heating is indicated by the
number of illuminated warning lights in the switch.
Fig. 53 Rear seats: Armrest
Fig. 54 Dash panel: Regulator for front
seat heating