Rear Seats - Skoda Octavia Tour Owner's Manual

– Press the locking button in the direction of arrow
locking button into the opening
maximum 5 mm and pull out the head restraint
– To re-insert the head restraint, push it down into the seat backrest far enough
until you hear the locking button engage.
WARNING
•
The head restraints must be correctly adjusted in order to offer effective
protection for the occupants in the event of an accident.
•
Do not drive under any circumstance with removed head restraints - risk of
injury!
•
If the rear seats are occupied, the rear head restraint must not be in the
lower position.

Rear seats

Folding the rear seats forwards
Fig. 50 Fold the seat cushion forwards/unlock the seat backrest
To enlarge the luggage compartment, the rear seats can be folded forwards, if
necessary remove the seat cushions. The rear seats can be folded forward individ-
ually on vehicles with divided rear seats*.
Folding seats forwards
– Before folding the rear seats forwards, you must adapt the position of the front
seats in such a way that they are not damaged when the rear seats are folded
forwards.
Using the system Safety
, press simultaneously the
A
using a flat screwdriver with a width of
B
 page 50, fig. 49.
Driving Tips
– Pull up the seat cushion in direction of arrow
of arrow  fig. 50.
2
– Press the unlocking knob and fold the seat backrest forwards.
A
If the front seats are too far back, we recommend that you have the rear head
restraints removed before the seat backrests are folded forward. Store the removed
head restraints in such a way that they cannot be damaged or soiled. Observe the
guidelines  page 53, "luggage compartment".
Move seats into the initial position
Move seats into the initial position
– Install the head restraint in the slightly lifted seat backrest.
– Place the rear lateral seat belt
 fig.
51.
– Then push the seat backrest back into the upright position until the securing
knob clicks into place - check by pulling on the seat backrest.
– Make sure that the red pin
B
– Move the seat cushion into its original position.
WARNING
•
The belts and the belt locks must be in their original position after folding
back the seat cushions and the seat backrests - they must be ready to use.
•
The seat backrests must be securely interlocked in position so that no
objects in the luggage compartment can slide forwards if there is sudden
braking - risk of injury!
General Maintenance Breakdown assistance
Seats and Stowage
and fold forwards in direction
1
Fig. 51 Lock the seat backrest
behind the edge of the side trim panel
C
is covered  fig. 50.
Technical Data
51