70
Heating and air conditioning system
which can only be eliminated through considerable effort and expense (replace-
ment of compressor).
Using the system
Fig. 82 Climatic: Control elements
Setting temperature
–
Turn the control dial
fig. 82
A
ture.
–
Turn the control dial
to the left in order to increase the temperature.
A
Controlling blower
–
Turn the blower switch
into one of the positions, 1 to 4, in order to switch the
B
blower on.
–
Turn the blower switch
into position 0 in order to switch the blower off.
B
–
If you wish to shut off the fresh air supply, use the button
air mode page 72.
Control for air distribution
–
You can adjust the direction of the air flow using the air distribution control
page 66.
switching cooling on and off
–
Press the button
fig.
AC
2
to the right in order to increase the tempera-
- recirculated
3
82. The warning light lights up in the button.
–
When you again press the switch
warning light in the button goes out.
Rear window heater
. Further information page 44, "Rear window heater".
–
Press button
1
Note
•
The whole heat output will be needed to unfrost the windscreen and side
windows. No warm air will be fed to the footwell. This can lead to restriction of the
heating comfort.
•
The used air streams out through the air removal openings in the luggage
compartment.
•
If the cooling system has not been switched on for a lengthy period, odours may
be produced at the evaporator because of deposits. Switch the cooling system on
at least once a month for approximately 5 minutes at the highest blower stage -
also during the cold season of the year - in order to remove such odours. Also open
a window for a short time.
•
Please refer to the information regarding recirculated air mode page 72.
C
AC
, the cooling system is switched off. The