•
Check for yourself that a safety wheel bolt is located in the hole in the area of
the valve before fitting the full wheel trim onto a steel wheel which is attached with
a safety wheel bolt page 152.
Wheel bolts with caps*
Pulling off
–
Push the plastic clip sufficiently far onto the cap until the inner catches of the
clip are positioned at the collar of the cap and detach the cap.
Installing
–
Push the caps fully onto the wheel bolts.
The caps are located in the well of the luggage compartment.
Wheel trim caps*
Using the system
Safety
Fig. 135 Removing the cap.
Fig. 136 Pulling off wheel trim cap on
light alloy wheels
Driving Tips
Pulling off
–
Carefully remove the wheel trim cap using the wire clamp
Slackening and tightening wheel bolts
Slacken the wheel bolts before jacking up the vehicle.
Slackening wheel bolts
–
Push the wheel wrench* fully onto the wheel bolt
–
Grasp the end of the wrench* and turn the bolt about one turn to the left
fig.
137.
Tightening wheel bolts
–
Push the wheel wrench* fully onto the wheel bolt
–
Grasp the end of the wrench* and turn the bolt to the right until it is tight.
WARNING
Slacken the wheel bolts only a little (about one turn) as long as the vehicle has
not yet been lifted with the lifting jack* - risk of accident!
Note
Apply pressure carefully with your foot to the end of the wrench* if it proves difficult
to slacken the bolts. Hold tight on the vehicle when doing this and ensure that you
have a steady position.
7)
Use the appropriate adapter for slackening and tightening the safety wheel bolts page 152.
General Maintenance
Breakdown assistance
Breakdown assistance
151
fig.
136.
Fig. 137 Changing a wheel: Slackening
wheel bolts
7)
.
7)
.
Technical Data