Variable Loading Floor In The Luggage Compartment (Estate) - Skoda Octavia Operating Instructions Manual

›
Place the rear bar against the front bar and press them together at both
ends .
B
›
The front hooks on both sides of the luggage compartment fold back oppo-
site to the direction of arrow
1
Removing/inserting
 The roll-up cargo cover must be removed.
›
Remove the pocket from the fittings in the direction of the arrow
» Fig. 117.
Insertion takes place in reverse order.
›
When inserting, push the end of the bar marked   into the right receptacle
and the end of the bar marked   into the left receptacle. The arrows should
be pointing forward.
Class N1 vehicles

Read and observe and
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.

Variable loading floor in the luggage compartment (Estate)


Introduction
This chapter contains information on the following subjects:
Positions of the variable loading floor
Fold up variable loading floor
Dividing the luggage compartment
The maximum permissible load of the variable loading floor is 75 kg. For the
transport of heavy loads, adjust the variable loading floor in the lower position
» Fig. 119 on page 106.
106
Using the system
.
on page 99 first.
Positions of the variable loading floor
6
Fig. 118 Set variable loading floor to the upper position / variable loading
floor in the upper position
Fig. 119 Set variable loading floor to the lower position / variable loading
floor in the lower position
The variable loading floor can be set to the upper or lower position.
Set to the upper position
106
›
Grasp the rear of the variable loading floor by the handle
107
›
Lift the variable loading floor about 20 cm, pull it to yourself and raise it in
107
the direction of the arrow
cover until it clicks.
After an audible click, the variable loading floor can be stowed in the upper po-
sition by pushing it forward.
The space available below the variable loading floor can be used for stowing
objects such as the removed roll-up luggage compartment cover
the roof cross bars
to the level of the roll-up luggage compartment
1
» page 110 etc.
» Fig. 118.
A
» page 103,
