Skoda Octavia Operating Instructions Manual page 120

Switching off
›
Manually with the symbol key  on the front panel of the Climatronic or the
manual air conditioning » Fig. 132.
›
Manually with the symbol key  on the radio remote control.
›
Via an automatically programmed and activated pre-set time in the Infotain-
ment.
›
Automatically when the warning light
nates.
›
Automatically according to the ambient conditions
After switching the system off, the auxiliary heating will continue running a lit-
tle while longer in order to burn the remaining fuel in the auxiliary heater.
After switching off, coolant pump still runs for a short period.
Programming the auxiliary heating in the Infotainment
For vehicles with Climatronic: On the operating element of the Climatronic →
press button  .
For vehicles with manual air conditioning: In the Infotainment press the button
→ .

When automatic switching on is activated, the indicator light in the symbol key
 lights up » Fig. 132 for about 10 seconds after the ignition is turned off.
CAUTION
The automatic switching on and off the heating for rapid heating of the vehicle
interior can be disabled in the Infotainment
ment, chapter Setting the heating and the cooling system.
Radio remote control
in the instrument cluster illumi-

» .
» Operating instructions Infotain-
Fig. 133
Radio remote control

Read and observe and
The radio remote control can be used to switch the auxiliary heating (heating
and ventilation) on or off.
Function and description of the radio remote control
Warning light
A
Aerial
B
Switch on the auxiliary heating

Switch off the auxiliary heating

To switch the auxiliary heating (aux. heating and ventilation) on or off, hold the
remote control vertical, with the aerial
tenna must not be covered with the fingers or the palm of the hand during this
process.
The auxiliary heating can only be switched on/off safely using the radio re-
mote control, if the distance between the radio remote control and the vehicle
is at least 2 m.
After pressing the button, the warning light in the remote control gives the
user different kinds of feedback.
Display warning light » Fig. 133
A
Lights up green for around 2 seconds.
Lights up red for around 2 seconds.
Slowly flashes green for around 2 sec-
onds.
Quickly flashes green for around 2
seconds.
Flashes red for around 2 seconds.
Lights up orange for around 2 sec-
onds, then green or red.
on page 116 first.
» Fig. 133
» Fig. 133 pointing upwards. The an-
B
Meaning
The auxiliary heating has been
switched on.
The auxiliary heating has been
switched off.
The ignition signal was not received.
The auxiliary heating is blocked, e. g
because the tank is nearly empty or
there is a fault in the auxiliary heat-
ing.
The switch off signal was not re-
ceived.
The battery is weak, however the
switching on or off signal was re-
ceived.
Heating and ventilation

117