Skoda Octavia Operating Instructions Manual page 154

Note
If control is started at a speed of less than 30 km/h on vehicles with an auto-
■
matic transmission, the speed of 30 km/h is stored. The speed increases auto-
matically to 30 km/h or is regulated with respect to the speed of the vehicle
ahead.
When TCS is disabled, it will be activated automatically upon starting control.
■
If the TCS is deactivated during control, control is stopped automatically.
■
Stop/resume control

Read and observe on page 148 first.
Stop control
›
Set the lever into the sprung position 
Or
›
Apply the brake.
Control stops, the speed remains stored.
Resume control
›
Start control » page 150.
WARNING
Control may only be resumed if the stored speed is not too high for the cur-
rent traffic conditions.
Note
Regulation is also stopped when the clutch is held down for longer than 30 s.
Set/change the desired speed

Read and observe on page 148 first.
The desired speed can be set or changed using the control lever
page 150.
The set speed is stored upon releasing the lever or the button on the button
on the lever.
Setting/changing the speed by 10 km/h at a time () - requirements
ACC is enabled.

» Fig. 163 on page 150 set.
» Fig. 163 on
Increasing the speed by 1 km/h at a time () - requirements
ACC is enabled.

Vehicle control taking place.

Decreasing the speed by 1 km/h at a time () - requirements
ACC is enabled.

Vehicle control taking place.

Changing the speed by adopting the current speed () - requirements
ACC is enabled.

The vehicle is moving at a speed other than that which is stored.

Note
If during control the speed is increased by pressing the accelerator, control is
■
temporarily stopped. Upon releasing the accelerator, control is automatically
resumed.
If during control the speed is reduced by applying the brake, control is stop-
■
ped. Control needs to be restarted in order to resume
If the vehicle is controlled by a lower speed than the stored speed, then 
■
the current speed is stored the first time the button is pressed. Press the but-
ton again  and the speed is reduced in increments of 1 km/h.
Set the clearance level

Read and observe on page 148 first.
The proximity to the vehicle ahead can be set with the lever
page 150 or in the Infotainment »
ter CAR - vehicle settings.
Setting by means of the lever
›
Set the switch  in the spring-tensioned position
» Fig. 163 on page 150.
The display of the instrument cluster shows line
which indicates the proximity.
›
Using the switch  on the lever, adjust line
level.
» page 150.
» Fig. 163
Operating instructions Infotainment, chap-
or adjust
-

» Fig. 161 on page 149,
2
to the desired distance
2
Assist systems
on

151