Skoda Octavia Operating Instructions Manual page 234

›
Press together the interlocks on the connector
›
Carefully remove the connector from the tail lamp assembly in the direction
of the arrow .
4
Fitting
›
Insert the bulb holder in the light.
The locks on the plug must be inserted securely.
›
Insert the lamp with the pin
A
» Fig. 243 in the body.
›
Carefully push the cover in »
›
Screw the tail lamp into place and install the cover.
The cover must engage securely.
CAUTION
Ensure that the cable bundle does not become pinched between the body
■
and the lamp when it is being refitted – risk of damage to the electrical instal-
lation and risk of water ingress.
If you are not sure whether the cable bundle has become pinched, we recom-
■
mend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing bulbs in the rear light - Variant 1
Fig. 244 Outer part of the light: Basic light/light with LED diodes
1)
The design of the plug can vary depending on the vehicle equipment.
in the direction of arrow
1)
» Fig. 244 on page 231 into the recesses
.
.
3
C
Fig. 245 Inner part of the light: Basic light/light with LED diodes

Read and observe
Outer part of the lamp
›
Turn the bulb holder
B
it from the lamp housing.
›
Push the faulty bulb into the holder, turn in anti -clockwise direction up to
the stop and remove.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Replace the holder with the bulb into the lamp housing and turn in a clock-
wise direction to the stop.
Inner part of the light
›
Unscrew the lamp holder
kit, and remove the lamp holder from the light assembly.
›
Turn the respective light bulb
remove it from the bulb holder.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Insert the bulb holder in the tail lamp assembly.
›
Screw on the lamp holder carefully.
and on page 227 first.
» Fig. 244 in an anti-clockwise direction and remove
» Fig. 244 with the screwdriver from the car tool
» Fig. 245 until it stops counter-clockwise and
Fuses and light bulbs
231