Oki MICROLINE ML380 Maintenance Manual page 376

12) Select emulation
(a) Code: ESC { n
(b) Compatibility: EPSON LQ/IBM
(c) Function:
This command allows the software developer to change the printer emulation to
access the features that match this requirements.
(d) Additional details:
• This command is not documented for public use.
• This command duplicates the MENU selection.
• When emulation is changed DLL will be cleared.
13) Printer initialization
(a) Code: ESC } NUL
(b) Compatibility: EPSON LQ/IBM
(c) Function:
• Upon receipt of this code the printer will be initialized to all its menu default
settings. This command is always active regardless of the menu "Reset Inhibit".
(d) Additional details:
• All data in the buffer will be cleared and the current printhead position becomes
top of page.
• DLL data will be deleted (EPSON).
14) Set initial condition
(a) Code: ESC [ K Ln Hn Init Id Parm1 Parm2
(b) Compatibility: IBM
(c) Function:
Sets initial conditions of printer
(d) Range:
• Ln, Hn ... Sets subsequent parameter bytes.
00H ≤ Ln ≤ FFH
00H ≤ Hn ≤ FFH
The subsequent parameter bytes is Ln + (Hn ¥ 256) bytes.
If Ln = Hn = 00H, data up to ESC [ K Ln Hn is dumped and this command mode
is canceled.
Normally, use Hn = 00H and also Ln = 01H – 04H.
• Init ... Sets initial conditions of printer.
Init = 00H
Settings of menu item A are retained.
Parm1 and Parm2 settings are set for each mode.
Init = 01H
Settings of menu item A are retained.
Parm1 and Parm2 settings are set for each mode.
40959201TX Rev.1
111 /