Oki MICROLINE ML380 Maintenance Manual page 326

7) Set n/360 inch fine line spacing
(a) Code: ESC [ n
(b) Compatibility: EPSON LQ
(c) Function:
Sets line spacing to n/360".
(d) Range:
• Range n = 0—255 Number of 1/360" increments.
(e) Additional details:
• Power on default or l-Prime signal resets the value by this command and sets the
value which is determined by Menu.
• No line feed occurs when n = 0.
• Top of form will not be set.
(f) Related functions:
• LF, VT, or CR (and condition of Auto LF is on) proceeds predetermined LF.
8) Set n/360 inch line spacing
(a) Code: ESC % 8 n
(b) Compatibility: IBM
(c) Function:
Sets line spacing to n/360".
(d) Range:
• Range n = 1—255 Number of 1/360" increments.
(e) Additional details:
• Power on default or l-Prime signal resets the value by this command and sets the
value which is determined by Menu.
• This command is ignored when n = 0.
• Top of form will not be set.
(f) Related functions:
• LF, VT, or CR (and when Auto LF is on) proceeds predetermined LF.
9) Line feed
(a) Code: LF
(b) Compatibility: EPSON LQ/IBM
(c) Function:
This command causes the data in the print buffer to be printed followed by a
movement to the next print line based on the current line spacing.
(d) Additional details:
• A carriage return will also be executed; in IBM PPR mode auto CR must be set
for CR to be executed.
• Line spacing pitch will be set by ESC A n, ESC 0, ESC 2, ESC 3 n, and ESC
[ n. Otherwise, the LF pitch will be set by Menu when power is on or l-Prime signal
is received.
• This code will cancel enlarged character mode set by the ESC SO (Epson mode
only) and SO code. If there is no data before the LF code or only spaces before
this code, just line feed is performed.
40959201TX Rev.1
61 /