Miele G 8050 Operating Instructions Manual page 8

Warning and Safety instructions
The following points should be
observed to assist in maintaining
quality standards, to protect users,
and to avoid damage to the machine
and items being cleaned.
Only use cleaning agents
designed for use in this type of
machine. Using unsuitable cleaning
agents could adversely affect the
machine, as well as items being
cleaned.
Only use low-foaming cleaning
agents. Incorrect cleaning agents,
as well as some types of soiling, can
cause a build-up of foam in the drum.
Foam can have an adverse effect on
the cleaning process.
Where a chemical additive is
recommended on technical
application grounds (e.g. a cleaning
agent), this does not imply that the
manufacturer of the machine accepts
liability for the effect of the chemical on
the items being cleaned.
Please be aware that changes in
formulation, storage conditions etc,
which may not be publicised by the
chemical manufacturer, can have a
negative effect on the cleaning result.
When using cleaning agents and
special application chemicals, it is
essential that the manufacturer's
instructions are followed. Only use such
chemicals for the purpose and in the
situation specifed, to the exclusion of
other chemicals, to avoid such dangers
as chemical reactions and material
damage.
8
The machine is designed for
operation with water and additive
cleaning agents only. Organic solvents
must not be used in this machine, as
there is the danger under certain
circumstances of fire or explosion.
(Although this is not the case with all
organic solvents, other problems could
arise with their use, for example
damage to rubber and synthetic
materials).
In critical applications where very
stringent requirements have to be
met, it is strongly recommended that all
the relevant factors for the process,
such as cleaning agents, water quality
etc., are discussed with the Miele
Application Technology specialists.
If cleaning and rinsing results are
subject to particularly stringent
requirements (e.g. chemical analysis,
specialised industrial processes etc.), a
regular quality control test must be
carried out by the user to ensure that
required standards of cleanliness are
being achieved.
The special inserts should only be
used for their specific application.
Empty any containers or utensils
before arranging them in the
machine.