Problem Solving Guide - Miele G 8050 Operating Instructions Manual

Problem solving guide

With the aid of the following guide, minor problems can be easily corrected
without calling in a Miele service technician, saving you both time and money.
,
Repairs should only be carried out by a suitably qualified and trained
person in accordance with local and national safety regulations. Unauthorised
or incorrect repairs could cause personal injury or damage the dishwasher.
Problem
The "Start/Stop"
indicator light does not
flash after the appliance
has been switched on
with the "On/Off" button.
The dishwasher stops
during a programme.
The "Water inlet"
indicator light lights up
and flashes alternately.
46
Possible cause
The door is not properly
closed.
The appliance is not
plugged in.
The fuse is defective or
has tripped.
The fuse is defective or
has tripped.
The stopcock is closed.
The water inlet filter is
blocked.
The Waterproof system
has reacted.
Remedy
Close the door firmly.
Insert the plug.
Replace the fuse
(see data plate for
minimum fuse rating).
Replace the fuse
(see data plate for
minimum fuse rating).
Open the stopcock fully.
Before rectifying the
problem you must:
– Press the "Start/Stop"
button for at least one
second.
– Switch the dishwasher
off using the "On/Off"
button.
Then:
– Clean the water inlet
filter, see "Cleaning the
water inlet filter".
Call the Miele Service
Department.