Fujitsu Sparc Enterpise M8000 Product Notes page 49

XCP Issues Fixed in Releases Earlier Than XCP 1092 (Continued)
TABLE 6
ID Description
RTIF1- On the XSCF Web, when you changed the
070824-005 Refresh Interval value of the Monitor Message
Frame, the invalid pop-up "Confirmation
Domain mode" may appear.
RTIF1- On the tab browser, to the same host, when
070824-006 you perform multiple log-in with the user
accounts of different user privileges, the user
privilege of the last log-in user account will be
applied to those pages which you've already
logged in.
RTIF1- When you change configuration on the XSCF
070824-007 Web, if you select cancel on the confirmation
dialog or perform forced close, the original
configuration page may be unavailable.
RTIF1- On the Domain Configuration screen, when
070824-008 you select an undefined Domain ID, the
Configuration Policy remains as the content
which previously displayed.
RTIF1- While using Firefox 2, in the Configuration
070824-011 policy setting on the Domain Configuration
screen, when you specify a domain which is in
operation, an error display pop-up appears.
When you click on the Back button on this
error display pop-up and click on the Cancel
button on the inquiry screen to re-display the
data, the system remains in the error message
screen.
RTIF1- CLIs executed in Standby XSCF should display
070904-001
"Permission denied".
RTIF1- When the snapshot CLI attempts to write to a
070904-002 USB stick that has write protect set results in
an I/O error.
RTIF1- An incorrect domain state is reported. After
070904-003 the command sendbreak(8) to domain is
issued, showdomainstatus(8) continues to
show the state as "Running" when the domain
is actually at "ok" prompt.
Workaround
Ignore the pop-up and close the screen.
When you use the tab browser, do not perform
multiple log-in to the same host.
From the Menu, select the original
configuration page again.
None available at this time.
From the Menu, select the Domain
Configuration page again.
Only the following CLIs can be executed on
the Standby XSCF: snapshot(8),
switchscf(8).
Do not attempt to run any other CLI on the
Standby XSCF. Such attempts will report
various errors.
Do not attempt to use write-protected USB
devices for collecting snapshot.
No workaround is available. This is expected
behavior of the sendbreak(8) operation.
Information About Software 37