Xcp Issues Fixed In Releases Earlier Than Xcp 1092 - Fujitsu Sparc Enterpise M8000 Product Notes

XCP Issues Fixed in XCP 1092 (Continued)
TABLE 5
ID Description
RTIF1- When you use the setnameserver(8)
091109-003 command or the DNS setting of XSCF Web to
register the DNS server or the search path, you
can specify two or more same IP address
values or domain names.
However, when you specify two or more same
IP address values or domain names to delete
all the DNS servers or the search paths which
are same, it returns an invalid parameter.
RTIF1- When you start up a domain from a disk
091109-004 connected to the 8-Gbps fibre channel card
(SE0X7F21F, SE0X7F22F), if you fail to specify
the correct device path, an error log with no
message might be registered.
In the same way, when you start up a domain
from a disk connected to the 8-Gbps fibre
channel card (SE0X7F21F, SE0X7F22F), even if
the domain cannot be started due to reasons
such as disk failure, the error log might not be
registered.
RTIF1- The loadcert console operand is missing in
091105-001 the usage of the setad(8) command and the
setldapssl(8) command.
XCP Issues Fixed in Releases Earlier Than XCP
1092
TABLE 6

XCP Issues Fixed in Releases Earlier Than XCP 1092

TABLE 6
ID Description
RTIF1- All domains must be powered off before
070418-004 upgrading the XCP firmware.
RTIF1- If you log in to the XSCF while it is still
070418-005 booting, you may get a bash$ prompt instead
of the XSCF> prompt, and be unable to
perform most operations.
34 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1092 • April 2010
lists XCP issues that have been fixed in releases earlier than XCP 1092.
Workaround
To delete all the DNS servers or the search
paths which are same, specify just one
corresponding address or domain name.
In doing so, all the DNS servers or the search
paths which are same will be deleted. Register
the data again as needed.
No workaround is available.
For how to use the loadcert console
operand of the setad(8) command and the
setldapssl(8) command, see the man page.
Workaround
Power off domains before using the
flashupdate(8) command to upgrade XCP
firmware.
Log out of the bash$ prompt and wait for the
XSCF to finish booting.