Solaris Os Issues Fixed In Solaris 10 5/09 - Fujitsu SPARC Enterprise M4000 Product Notes

Solaris OS Issues Fixed in Solaris 10 10/09 (Continued)
TABLE 8
CR ID Description
6827340 DR and Memory patrol might fail due to
command error.

Solaris OS Issues Fixed in Solaris 10 5/09

TABLE 9
them in supported releases earlier than Solaris 10 5/09.
Solaris OS Issues Fixed in Solaris 10 5/09
TABLE 9
CR ID Description
6588555 XSCF reset during DR operation to the
permanent memory might cause domain
panic.
6623226 The Solaris command lockstat(1M) or the
dtrace lockstat provider might cause a system
panic.
6680733 Sun Quad-port Gigabit Ethernet Adapter UTP
(QGC) & Sun Dual 10 GigE Fiber XFP Low
Profile Adapter (XGF) NICs might panic under
high load conditions.
6689757 Sun Dual 10 GigE Fiber XFP Low Profile
Adapter (XGF) with a single or improperly
installed XFP optical transceivers might cause
the following error to show on the console:
The XFP optical transceiver is
broken or missing.
40 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1091 • April 2010
lists issues that have been fixed in Solaris 10 5/09 OS. You might encounter
Workaround
This has been fixed in patch 142344-01.
No workaround is available.
Workaround
This has been fixed in patch 139555-08.
[Workaround]
Do not start an XSCF reset while a DR
operation is running. Wait for a DR operation
to finish before starting the reset.
This has been fixed in patch 140336-01.
[Workaround]
Do not use the Solaris lockstat(1M)
command or the dtrace lockstat provider.
This has been fixed in patch 139570-01.
This has been fixed in patch 139570-01.
[Workaround]
Check and make sure that both XFP optical
transceivers are firmly seated in the housing.
Do not mix INTEL and Sun XFP optical
transceivers in the same Adapter.
Do NOT plumb a port with the ifconfig
command if the port does not contain an XFP
optical transceiver or it contains one but the
transceiver is not in use.