Solaris Os Issues Fixed In Solaris 10 5/09 - Fujitsu Sparc Enterpise M8000 Product Notes

Solaris OS Issues Fixed in Solaris 10 5/09

TABLE 9
them in supported releases earlier than Solaris 10 5/09.
Solaris OS Issues Fixed in Solaris 10 5/09
TABLE 9
CR ID Description
6588555 XSCF failover during DR operation to the
permanent memory might cause domain
panic.
6623226 The Solaris command lockstat(1M) or the
dtrace lockstat provider might cause a system
panic.
6680733 Sun Quad-port Gigabit Ethernet Adapter UTP
(QGC) & Sun Dual 10 GigE Fiber XFP Low
Profile Adapter (XGF) NICs might panic under
high load conditions.
6689757 Sun Dual 10 GigE Fiber XFP Low Profile
Adapter (XGF) with a single or improperly
installed XFP optical transceivers might cause
the following error to show on the console:
The XFP optical transceiver is
broken or missing.
56 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1092 • April 2010
lists issues that have been fixed in Solaris 10 5/09 OS. You might encounter
Workaround
This has been fixed in patch 139555-08.
[Workaround]
Do not start an XSCF failover while a DR
operation is running. Wait for a DR operation
to finish before starting the failover. If you
start the failover first, wait for the failover to
finish before starting the DR operation.
This has been fixed in patch 140336-01.
[Workaround]
Do not use the Solaris lockstat(1M)
command or the dtrace lockstat provider.
This has been fixed in patch 139570-01.
[Workaround]
If posible, use the card in x8 slot. Otherise,
there is no workaround.
This has been fixed in patch 139570-01.
[Workaround]
Check and make sure that both XFP optical
transceivers are firmly seated in the housing.
Do not mix INTEL and Sun XFP optical
transceivers in the same Adapter.
Do NOT plumb a port with the ifconfig
command if the port does not contain an XFP
optical transceiver or it contains one but the
transceiver is not in use.