Configuring Xscf For Active Directory Support; Configuring Xscf For Ldap/Ssl Support - Fujitsu Sparc Enterpise M8000 Product Notes

Note – If you are an Active Directory or LDAP/SSL user, do not upload a public
key. If one has already been uploaded, use the following command to delete it:
XSCF> setssh -c delpubkey -a -u proxyuser
If you are an Active Directory or LDAP/SSL user, be sure to log in to the XSCF
network through the SSH service by the authentication not with the user public key
but with the password.

Configuring XSCF for Active Directory Support

The commands setad(8) and showad(8) let you set and view the Active Directory
configuration from the command line.
By default, Active Directory support is disabled. To enable Active Directory support,
use the following command:
XSCF> setad enable
To disable Active Directory support, use the following command:
XSCF> setad disable
To show if Active Directory support is enabled or disabled, enter:
XSCF> showad
Use the setad(8) command with its various parameters to configure Active
Directory. For example, you can use it to set up one primary and five alternate
Active Directory servers, assign group names and privileges, configure a particular
user domain, control logging of diagnostic messages, and more. User domain can be
configured explicitly through the setad userdomain command on XSCF, or
entered at login prompt using the form, user@domain.
See the setad(8) and showad(8) man pages, and the note about these commands in
TABLE 13

Configuring XSCF for LDAP/SSL Support

The commands setldapssl(8) and showldapssl(8) let you set and view
LDAP/SSL configuration from the command line. These commands do for
LDAP/SSL what the setad(8) and showad(8) commands do for Active Directory,
and support many of the same parameters.
For more information, see the setldapssl(8) and showldapssl(8) man pages.
30 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1092 • April 2010
.