Information About Hardware; Antistatic Precautions - Fujitsu Sparc Enterpise M8000 Product Notes

Information About Hardware

This section describes the special instructions and the issues about the SPARC
Enterprise M8000/M9000 servers hardware.
"Antistatic Precautions" on page 11
■
"Notes on DVD Drive and Discs" on page 18
■
"Notes on the Use of USB Memory" on page 18
■
"Power Control and Operator Panel Mode Switch" on page 19
■
"Hardware Issues and Workarounds" on page 19
■
"Hardware Documentation Updates" on page 20
■
"Cabinet Stabilization Measures" on page 26
■

Antistatic Precautions

Caution - Before handling FRUs, be sure to connect an antistatic wrist strap clip
and an antistatic conductive mat to a cabinet grounding port and attach the band of
the wrist strap to one of your wrists. Remove static electricity on the FRUs before
installation by placing the FRUs on a grounded antistatic conductive mat while
wearing the wrist strap. Failure to do so might result in serious damage.
Be sure to observe the precautions when handling the FRUs described in the below
chapters in the SPARC Enterprise M8000/M9000 Servers Service Manual.
Chapter 6: Replacement of CPU/Memory Board Unit (CMU), CPU, and DIMM
■
Chapter 7: I/O Unit (IOU) Replacement
■
Information About Hardware 11