Checking The Gear Oil Level; Checking The Battery (E And W Model); Connecting The Throttle Cable And Shift Cable - Yamaha F30A Service Manual

GEN
INFO

Checking the gear oil level

1. Check the gear oil level.
NOTE:
If the oil is at the correct level, a small
amount of oil should overflow out of the
check hole when the gear oil check screw is
removed.
Checking the battery (E and W
model)
1. Check the battery capacity, electrolyte
level, and specific gravity of the electro-
lyte.
Recommended battery capacity:
CCA/EN: 430 A
20HR/IEC: 70 Ah
Electrolyte specific gravity:
1.280 at 20 °C (68 °F)
2. Check that the positive and negative bat-
tery cables are securely connected.
Connecting the throttle cable and
shift cable
NOTE:
To adjust the throttle cable and shift cable,
see "Adjusting the throttle cable" (3-8) or
"Checking the gear shift operation" (3-9).
1. Set the shift lever or remote control lever
to the N position and the throttle grip or
throttle lever to the fully closed position.
1-15
General information
S67C1019
2. Turn the throttle cam 1 clockwise until
the cam contacts the fully closed stopper
a on the throttle cam bracket 2 and
hold it in that position. Connect the throt-
tle cable 3 to the throttle cam, and then
install the clip 4.
4
3
1
3. Check that the shift arm 5 is in the N
position as shown. Connect the shift
cable 6 to the shift arm, and then install
the clip 7.
7
6
N
R F
5
WARNING
The shift/throttle cable joint must be
screwed in a minimum depth of 8.0 mm
(0.31 in) b.
a
2
S67C1020
d
c
S67C1021
b
S67C1047
67C3K11