Yamaha F30A Service Manual page 171

8
9
6
7
a
8
NOTE:
After connecting the shift rod 8, check that
the gear shift operates properly.
Screwed in length a:
8.0–9.0 mm (0.31–0.35 in)
6. Install the anode 0, trim tab A, and
cooling water inlet covers B, and then
tighten the trim tab bolt C and cooling
water inlet cover screw D to the speci-
fied torques.
B
Trim tab bolt C:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Cooling water inlet cover screw D:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
7. Install the propeller E and propeller nut
F. Place a block of wood between the
anti-cavitation plate and propeller to keep
the propeller from turning, and then
tighten the nut to the specified torque.
67C3K11
S67C6059
0
A
B
LT
572
C
D
S67C6060
Drive shaft and lower case
D
WARNING
• Do not hold the propeller with your
hands when loosening or tightening the
propeller nut.
• Be sure to disconnect the battery cables
from the battery and remove the clip
from the engine shut-off switch. (E and
W model)
NOTE:
If the grooves in the propeller nut F do not
align with the cotter pin hole, tighten the nut
until they are aligned.
Propeller nut F:
39 N·m (3.9 kgf·m, 28.8 ft·lb)
8. Fill the lower unit with gear oil to the cor-
rect level.
Recommended gear oil:
Hypoid gear oil
API: GL-4
SAE: 90
Gear oil quantity:
3
430 cm
(14.54 US oz, 15.17 Imp oz)
F
E
S67C6061
S67C6108
6-20
1
2
3
4
5
6
7
8
9